Lanyard Wiring - 2007 Sherco

Got a technical question? Ask it in here.

Moderator: Moderators

bforsyth
Junior participant
Junior participant
Posts: 9
Joined: Fri Feb 08, 2019 1:56 pm
Bike: Gas Gas
Location: Warragul, Vic
Location: Australia

Lanyard Wiring - 2007 Sherco

Postby bforsyth » Mon Mar 04, 2019 5:44 pm

Hey all.
I have an older Sherco 2.9 that I am hoping to do some club level stuff on.
I have a magnetic lanyard ready to go, but not too sure how to wire it in? The bike still has the standard switch block for lights/kill switch and a horn?

I found this via Google. It's an earlier bike, but should be the same I imagine?
http://shercousa.com/pdfs/ryp_wiring_installation.pdf

Shouldn't be too hard to make up the same harness?

Is there a quicker solution?
Ben



outforfun
B grade participant
B grade participant
Posts: 85
Joined: Tue Sep 10, 2013 7:51 pm
Bike: 2002 Sherco 290
Club: WDTC

Re: Lanyard Wiring - 2007 Sherco

Postby outforfun » Wed Mar 13, 2019 11:12 am

Hi Ben, mine is a 2002 290 and I didn't buy a harness or cut and splice the old harness. I took the switch block off and took it to my bike shop, an auto electrical place can help too.

But I got the same plug that is on the Sherco switch block and a couple of terminals to suit.

Once you check your Sherco's wiring for correct colours. I cut the ends off the lanyard wiring and fitted the new terminals.

Simply plug and play. I did fill the back of the new plug with silicone to keep water out when I wash the bike though.
Attachments
20190313_100845.jpg
20190313_100845.jpg (616.82 KiB) Viewed 12625 times



bforsyth
Junior participant
Junior participant
Posts: 9
Joined: Fri Feb 08, 2019 1:56 pm
Bike: Gas Gas
Location: Warragul, Vic
Location: Australia

Re: Lanyard Wiring - 2007 Sherco

Postby bforsyth » Sat Mar 16, 2019 6:57 pm

OK, I did try Repco and Autobarn for a plug with no luck. I'll see if the auto specs have something.




Return to “Technical help”

Who is online

Users browsing this forum: No registered users and 18 guests