Non destructive testing and engine part measuring
Moderator: Moderators
-
- Junior participant
- Posts: 6
- Joined: Fri Nov 22, 2019 7:44 am
- Bike: Buying a project
- Location: Australia
Non destructive testing and engine part measuring
I just bought a cheap engine with a stuffed top end from a broken valve. I want to get the crank, conrods and case tested for cracks and distortion before going to the expense of a rebuild. Anyone recommend where I can get this done in the Sydney region?
Re: Non destructive testing and engine part measuring
Any engine re builder can check for bent rods and crank and crack test same. I always get a crack test on an engine rebuild. The only time I've had cases tested they torqued them together and measured for bearing housing out of roundness with a inside micrometer. It was out of round so it was line bored. If they can do it in the central west it has to be easier down Sydney.
Who is online
Users browsing this forum: No registered users and 17 guests