Page 2 of 4
Re: My BETA REV3 200
Posted: Wed Oct 01, 2014 6:07 pm
by Craigus77
Thanks PA, I have a copy of this (or very close to) unfortunately there is no detail on the forks. Absolutely everything else though.. Unless I really am blind??
Re: My BETA REV3 200
Posted: Mon Oct 06, 2014 9:30 am
by Craigus77
Getting so close to complete now. Fluids are all changed, all new parts are on. Just waiting on chain and sprockets to arrive and it's GO-TIME!!
Check out the state of the gear mud err oil?!?!
Re: My BETA REV3 200
Posted: Mon Oct 06, 2014 1:16 pm
by KTM39
Where's the water coming from?
Re: My BETA REV3 200
Posted: Mon Oct 06, 2014 2:18 pm
by Craigus77
No water.. Just putrid oil, not been changed in a long long LONG time me thinks.
Re: My BETA REV3 200
Posted: Mon Oct 06, 2014 8:43 pm
by KTM39
Good. It must just be the reflection in the photo that makes one side of the bucket look milky.
Re: My BETA REV3 200
Posted: Mon Oct 06, 2014 9:08 pm
by Craigus77
I was a little worried about it actually seeing a lot of them leak coolant.
Parts arriving tomorrow should get to fire it up. Was hoping they would arrive Friday so I have the long weekend to play
Re: My BETA REV3 200
Posted: Tue Oct 07, 2014 8:06 pm
by Craigus77
Some more progress.. Actually got to ride it tonight. Still needs some tuning/float level and small bits but just about complete :)
Re: My BETA REV3 200
Posted: Tue Oct 07, 2014 8:16 pm
by TRIALTECH
why 2004 plastics?
Re: My BETA REV3 200
Posted: Tue Oct 07, 2014 8:17 pm
by TRIALTECH
header pipe looks good. replaced that too or just paint?
Re: My BETA REV3 200
Posted: Tue Oct 07, 2014 8:26 pm
by Craigus77
TRIALTECH wrote:header pipe looks good. replaced that too or just paint?
Thanks man.. Just painted it with heat proof 'rotor' paint with a good clean and quality primer :)