Frame welding
Posted: Mon Jan 02, 2006 12:57 pm
I'd just like to know what my frame is made of. One of the little tab things that are meant to hold the bash plate on is almost broken off. 
Trials Australia Forums
Our goal - promoting a MotoTrials Community
https://forum.trials.com.au/
Frame welding
Page 1 of 1
Posted: Mon Jan 02, 2006 1:59 pm
What bike do you ride?
Posted: Mon Jan 02, 2006 3:00 pm
Hi Lucas,
The Sherco is Chrome-molybdenum. Chromed finish (type/mix if steel). I think you can have it welded as normal but it will be dull after that. But I don't suppose that will matter, seeing as it is under the bike.
Best of balance.
Neo
The Sherco is Chrome-molybdenum. Chromed finish (type/mix if steel). I think you can have it welded as normal but it will be dull after that. But I don't suppose that will matter, seeing as it is under the bike.
Best of balance.
Neo
Posted: Mon Jan 02, 2006 4:40 pm
Sorry, Sherco 290. I figured Neo or BJ would be the first to replyPA wrote:What bike do you ride?
Posted: Mon Jan 02, 2006 4:41 pm
Thanks heapsNeo wrote:Hi Lucas,
The Sherco is Chrome-molybdenum. Chromed finish (type/mix if steel). I think you can have it welded as normal but it will be dull after that. But I don't suppose that will matter, seeing as it is under the bike.
Best of balance.
Neo
Posted: Mon Jan 02, 2006 5:37 pm
Did that PA beat me to a post????
I was too busy riding today and he gets me. I think a tig would be best but a mig should be ok! But don't let anyone near it with an ark unless they are really good.
I was too busy riding today and he gets me. I think a tig would be best but a mig should be ok! But don't let anyone near it with an ark unless they are really good.
Posted: Mon Jan 02, 2006 7:02 pm
I'm going to get it done professionally, I need a few things on my stuntbike done also.
Posted: Mon Jan 02, 2006 9:16 pm
I would think TIG would be the way to go.
Sorry I beat you to post there BJ.
Sorry I beat you to post there BJ.