Page 1 of 1
Bultaco kickstart return spring
Posted: Mon Dec 03, 2007 1:56 pm
by Ginge
Does anyone have any tips on fitting a new kickstart return spring to a Sherpa T?
Do I really have to split the cases...
Ginge
Posted: Mon Dec 03, 2007 8:05 pm
by David Lahey
On a Bultaco, you only have to remove the magneto flywheel cover to change the kickstart spring.
If you had to replace the kickstart travel stop or the kickstart shaft you would have to split the cases.
Changing the spring is a pretty fiddly job. A good pair of needle nose pliers usually helps.