Ty 350 mono shock 86 model

Golden Glove · Post by **Golden Glove** » Wed Feb 27, 2008 9:26 pm

Gday All.

Two quick questions here.

What tension is needed on the head bolts in the way of pounds/foot pressure. ( I am replacing blown head gasket and have a tension wrench)
Also

What would be the best fuel ratio to run this 86 model bike on just for general putting around?

Thanks in advance

tat ty · Post by **tat ty** » Thu Feb 28, 2008 6:55 pm

Hi Glove

I've had my TY350 since it was born and always mixed the oil at 50:1.

You could probably lean this if you wish, but don't imagine any benefit. Mine still pulls strongly, doesn't blow an abnormal amount of smoke and doesn't oil up the plug.

I'll track down the service manual, it may have the required head bolt tension.

Stay tuned.

Golden Glove · Post by **Golden Glove** » Thu Feb 28, 2008 8:51 pm

Thanks mate

Thats the fuel worked out

Just need head tension now

Cheers

Tee-Why · Post by **Tee-Why** » Fri Feb 29, 2008 12:41 pm

All your info is found on this website that you require:
http://www.northover.com/Bike/YamahaTYManual.htm

Here is the torques you require on this page:
http://www.northover.com/Bike/Chapter6- ... orques.jpg

Cheers,
Roger

Golden Glove · Post by **Golden Glove** » Fri Feb 29, 2008 1:27 pm

Thanks mate for taking the time to drag that up for me.

Going down to the shed to do it now.

All questions answered

TOPIC CLOSED

Ty 350 mono shock 86 model

Ty 350 mono shock 86 model

Re: Ty 350 mono shock 86 model

Re: Ty 350 mono shock 86 model

Re: Ty 350 mono shock 86 model

Re: Ty 350 mono shock 86 model