Trials Australia Forums

I will be pulling down my engine shortly. I welcome any advice before I attemp this. The reasons are I spring the cases, and now have an oil leak for the gearbox, and a main bearing noise, picked up by an experienced member in the club.
I would like a run down on parts needed/recomended, and any tips with tricks on disassembly.
TIA - Thanks in advance to all replies.

This job has been and gone months ago. It goes well now with new main bearings and seals.
Jetting has been played with since and still fine tuning.
I will a later date post a thread to my web page for some pics and tips, when I get a chance to setup it up properly.
Roger.

anymore info on this?