G'day, hope you guys can help. Have installed new races in the frame top and bottom
that came with the new roller bearings. I matched the stamped numbers and brand so all should be sweet. But: the top race sits a nats just below flush with the frame, so the bearing sits a tad high, which I assume is the way things should be so the top section has something to turn on. Is this right? The race will not go in any further. The botttom race is in snug as, but more recessed, with space for what I assume is to accomodate the black rubber dust seal that comes as part of and at the base of the bearing. Again, does this sound right? I question it because the seal doesn't slip into space readily and I wondered whether it might have to be spread out instead. Sorry this is a bit long winded but I don't have any photos nor can I find any reference anywhere. Hope someone on the forum has some answers. Many thanks. AB Brisbane.
TY250R Pinky Steering Head Bearings
Moderator: Moderators