Page 1 of 1
Ty 350 mono shock 86 model
Posted: Wed Feb 27, 2008 9:26 pm
by Golden Glove
Gday All.
Two quick questions here.
What tension is needed on the head bolts in the way of pounds/foot pressure. ( I am replacing blown head gasket and have a tension wrench)
Also
What would be the best fuel ratio to run this 86 model bike on just for general putting around?
Thanks in advance
Re: Ty 350 mono shock 86 model
Posted: Thu Feb 28, 2008 6:55 pm
by tat ty
Hi Glove
I've had my TY350 since it was born and always mixed the oil at 50:1.
You could probably lean this if you wish, but don't imagine any benefit. Mine still pulls strongly, doesn't blow an abnormal amount of smoke and doesn't oil up the plug.
I'll track down the service manual, it may have the required head bolt tension.
Stay tuned.
Re: Ty 350 mono shock 86 model
Posted: Thu Feb 28, 2008 8:51 pm
by Golden Glove
Thanks mate
Thats the fuel worked out
Just need head tension now
Cheers
Re: Ty 350 mono shock 86 model
Posted: Fri Feb 29, 2008 12:41 pm
by Tee-Why
All your info is found on this website that you require:
http://www.northover.com/Bike/YamahaTYManual.htmHere is the torques you require on this page:
http://www.northover.com/Bike/Chapter6- ... orques.jpgCheers,
Roger
Re: Ty 350 mono shock 86 model
Posted: Fri Feb 29, 2008 1:27 pm
by Golden Glove
Thanks mate for taking the time to drag that up for me.
Going down to the shed to do it now.
All questions answered
TOPIC CLOSED
